Endress+Hauser Proline Promag W 400 - Simulation

Commissioning Proline Promag W 400 EtherNet/IP
96 Endress+Hauser
Options Description
Compare The device configuration saved in the display module is compared with the current
device configuration of the integrated HistoROM.
Clear backup data The backup copy of the device configuration is deleted from the display module of
the device.
While this action is in progress, the configuration cannot be edited via the local
display and a message on the processing status appears on the display.
10.9 Simulation
The Simulation submenu enables you to simulate, without a real flow situation, various
process variables in the process and the device alarm mode and to verify downstream
signal chains (switching valves or closed-control loops).
The parameters displayed depend on:
• The selected device order
• The set operating mode of the pulse/frequency/switch outputs
Navigation
"Diagnostics" menu → Simulation
‣
Simulation
Assign simulation process variable
Value process variable
Simulation device alarm
Diagnostic event category
Simulation diagnostic event
Parameter overview with brief description
Parameter Prerequsite Description Selection / User
entry
Factory setting
Assign simulation process variable – Select a process variable for
the simulation process that is
activated.
• Off
• Volume flow
• Mass flow
• Conductivity
Off
Value process variable A process variable is selected
in the Assign simulation
process variable parameter.
Enter the simulation value for
the selected process variable.
Signed floating-point
number
0
Simulation device alarm – Switch the device alarm on and
off.
• Off
• On
Off