Endress+Hauser Proline Promag W 400 - Defining the Tag Name; Setting the System Units

Commissioning Proline Promag W 400 EtherNet/IP
80 Endress+Hauser
ECC cleaning cycle
ECC Polarity
‣
Administration
‣
Define access code
Define access code
Confirm access code
Device reset
10.6.1 Defining the tag name
To enable fast identification of the measuring point within the system, you can enter a
unique designation using the Device tag parameter and thus change the factory setting.
1
XXXXXXXXX
A0013375
 23 Header of the operational display with tag name
1 Device tag
The number of characters displayed depends on the characters used.
Entry of the tag name in the "FieldCare" operating tool →  69
Navigation
"Setup" menu → Device tag
Parameter overview with brief description
Parameter Description User entry Factory setting
Device tag Enter the name for the measuring point. Max. 32 characters, such as
letters, numbers or special
characters (e.g. @, %, /).
Promag 400
10.6.2 Setting the system units
In the System units submenu the units of all the measured values can be set.
Navigation
"Setup" menu → Advanced setup → System units