Endress+Hauser Proline Promag W 400 - Turning the Display Module

Installation Proline Promag W 400 EtherNet/IP
34 Endress+Hauser
Step Fixing screw Tightening torques for housing made of:
Aluminum Plastic
1 Housing cover 2.5 Nm (1.8 lbf ft) 1 Nm (0.7 lbf ft)
5 Smart sensor electronics module 0.6 Nm (0.4 lbf ft)
7 Main electronics module 1.5 Nm (1.1 lbf ft)
10 Transmitter housing 5.5 Nm (4.1 lbf ft)
NOTICE
Plug of the smart sensor electronics module connected incorrectly!
No measuring signal is output.
‣
Plug in the plug of the smart sensor electronics module as per the coding.
PUSH TO
REMOVE
A0021585
‣
Reverse the procedure to reassemble the measuring device.
6.2.6 Turning the display module
The display module can be turned to optimize display readability and operability.
TX 20
4 x
1.
2.
PUSH TO
REMOVE
PUSH TO
REMOVE
3.
4.
A0021617
1. Loosen the fixing screws of the housing cover (when reassembling, pay attention to
the tightening torque →  35).
2. Open the housing cover.
3. Unlock the display module.
4. Pull out the display module and turn it to the desired position in increments of 90°.