Endress+Hauser Proline Promag W 400 - Page 92

Commissioning Proline Promag W 400 EtherNet/IP
92 Endress+Hauser
Parameter overview with brief description
Parameter Prerequsite Description Selection / User
entry
Factory setting
Format display – Select how measured values
are shown on the display.
• 1 value, max. size
• 1 bargraph + 1
value
• 2 values
• 1 value large + 2
values
• 4 values
1 value, max. size
Value 1 display – Select the measured value that
is shown on the local display.
• Volume flow
• Mass flow
• Conductivity
• Temperature
• Electronic
temperature
• Totalizer 1
• Totalizer 2
• Totalizer 3
Volume flow
0% bargraph value 1 – Enter 0% value for bar graph
display.
Signed floating-point
number
0 l/h
100% bargraph value 1 – Enter 100% value for bar
graph display.
Signed floating-point
number
0.025 l/h
Decimal places 1 – Select the number of decimal
places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
Value 2 display – Select the measured value that
is shown on the local display.
Picklist (see 1st
display value)
None
Decimal places 2 – Select the number of decimal
places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
Value 3 display – Select the measured value that
is shown on the local display.
Picklist (see 1st
display value)
None
0% bargraph value 3 An option was selected in the
Value 3 display parameter.
Enter 0% value for bar graph
display.
Signed floating-point
number
0
100% bargraph value 3 An option was selected in the
Value 3 display parameter.
Enter 100% value for bar
graph display.
Signed floating-point
number
0
Decimal places 3 – Select the number of decimal
places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx
Value 4 display – Select the measured value that
is shown on the local display.
Picklist (see 1st
display value)
None
Decimal places 4 – Select the number of decimal
places for the display value.
• x
• x.x
• x.xx
• x.xxx
• x.xxxx
x.xx