86
Section 4 - Algorithms
11
- Noise Gate Off Below Range: -96 to +00 dB
This
parameter
sets the lower threshold level
at
which the
noise
gate
shuts
off the
audio
.
12 - Noise Gate On Above Range: -96 to +00 dB
This
parameter
sets the
upper
threshold level
at
which the
noise
gate passes the audio.
The
higher
second
threshold
prevents false
"tum
ons."
13 - Gate Release Time
Range: 1
ms
to 10.0s
This
parameter
sets the
amount
of time after the signal
has
elapsed
for
the
noise
gate
to
shut
down.
For
a
longer
sustain, set this
parameter
higher.
14 - Speaker High Pass Cutoff
Range: 4 to 1000 Hz
This
parameter
filters
out
the low frequencies of the
main
amp
prior
to the speaker. The
higher
the
value,
the
less low frequencies pass
through
.
15 - OutEQ1
Fc
Range: 100 to 9999 Hz
This
parameter
determines the filter center frequency of
the
parametric
in
the
main
amp
stage.
Higher
values
have
a brighter sound.
16 - OutEQ1 Gain
Range: -48 to +24 dB
This
parameter
adjusts the
amount
of boost
or
cut
applied to
the
main
amp
parametric.
17-0utEQ1
Q
Range:
01
to 18
This
parameter
determines the
width
of the resonant
peak
of
the
filter center.
While
the
Filter
center
parameter
determines where (at
what
frequency) this
peak
will occur, the Q
setting
controls the presence of the peak.
18 - OutEQ2 Fc
Range: 100 to 9999 Hz
This
parameter
determines the filter center frequency of
the
second
parametric
in
the
main
amp
stage.
Higher
values
have
a brighter
sound
.
19 - OutEQ2 Gain Range: -48 to +24 dB
This
parameter
adjusts the
amount
of
boost
or
cut
applied to
the
second
main
amp
parametric.
20-0utEQ2
Q
Range:
01
to 18
This
parameter
determines the
width
of the resonant
peak
of
the
second filter center.
21
- Speaker Low Pass Cutoff Range: 2.0 to 16.0 KHz
This
parameter
filters
out
the
high
frequencies of the speaker. The
lower
the value,
the
less
high
frequencies
pass
through.
This speaker filter is less selective
than
the speaker
cabinet
emulation
algorithms
which
are
provided
in the
DP
/
4.
22 - Mod1 Source
23 - Mod1 Destination
24 - Mod1 Param Range Min
25 - Mod1 Param Range Max
26 - Mod2 Source
27 - Mod2 Destination
28 - Mod2 Param Range Min
29 - Mod2 Param Range Max
See
the
descriptions
under
the Algorithm Modulators earlier
in
this section.
ENSONIQ DP/4 Musician's Manual
To Next Page
Loading...
Need help?
General
