Section 2 - Getting Started
Iliij"
Important:
There are
two
ways
that
the OP
/4
tells you which type of Preset
you
are
selecting:
•
In
Select mode,
when
you
press
any
of the Unit buttons (A, B,
C,
or D), either 1, 2,
or
4 of the
yellow
Unit
LEOs will light. The
number
of lighted LEOs corresponds to the
type
of
preset
you
will
be
selecting
if
you
move the Data Entry Knob. The yellow Unit LEOs also tell
you
which
~t(s)
will be
loaded
with
a
new
algorithm
if
you
select a
new
preset.
• Also,
the
display gives
you
constant feedback. For all Preset types, the
upper
line of the
display
shows
the
preset
name. The lower line shows
how
many
units are
in
the
preset
you
are selecting:
Dark
Hall
I=I:Hall
Reverb
In a 1-Unit preset, the lower
line of the display shows the
full name of the algorithm
in
the preset, and indicates
which unit the preset will be
loaded into.
Selecting Config Presets
lJocal
Chain
32
I=I:CMP
~
B:rev
In
a 2-Unit preset, the lower
line shows the 3-letter
abbreviations for the
algorithms
in
both units,
and indicates which 2 units
the preset will be loaded into
(A&B or C&D).
CleanFlan9Gui~ar
CMP~fla~ddl+rev
In
a 4-Unit preset, the lower
line of the display shows
3-letter abbreviations for
the algorithm
in
all 4 units.
By definition a 4-Unit preset
will load new algorithms into
all four units.
Of
the four Preset types, the
most
powerful is the Con
fig
Preset. The Config
preset
lets
you
save,
and
later recall, the
current
state of the OP /
4,
including all algorithm, signal
routing
and
mixing
information.
Selecting
a
Config
preset
will:
• Reconfigure the OP / 4
inputs
and
outputs;
•
Change
the signal
routing
between units;
and
•
Load
a
new
algorithm into each of the four Units.
To select a
Config
preset:
1. Press Select.
2.
If
the
Config LED is
not
already on, press Config.
3.
Move the
Data
Entry Knob. The Select LED flashes, indicating that
you
are
previewing
presets. The display shows the available Config presets.
4.
When
the display is
showing
the preset
you
want
to load, press Select again. This selects the
preset,
and
the Select LED stops flashing.
Note:
In
its
default
state, the OP / 4 only allows you to select
among
twelve Config
presets
(ROM locations 50-61). These have been
programmed
to give
you
easy
access
to the
most
commonly
used
configs.
When
you
want
to select
among
more
Config presets, or to save
your
own,
you
can
"reveal" the
remaining
88 Config presets
by
turning
the "Show 100 Config Presets" switch to Yes. This switch
(parameter 59
in
System.
MIDI mode) unveils functions which have
been
hidden
to avoid
confusion for the first-time user.
ENSONIQ DP/4 Musician's Manual
31
To Next Page
Loading...
Need help?
General
