Section 2 - Getting Started
Editing Config Parameters
.
Editing
the
parameters of a config is similar to editing the algorithm
parameters
in
a
unit
-
parameter
#00 is the Input
Config
Select
,
and
the remaining
parameters
will
vary
depending
on
the config
you
select. Press the Left/Right Arrow buttons to select parameters
and
move
the
Data
Entry
Knob
to change the value of the active (flashing)
parameter
.
To
edit
Config parameters:
1.
Press Edit.
2
If
the
yellow Config LED is
not
already on, press Config. The display
shows
:
Parameter Number Input Config Select
nn
LILI
1
Source
Confi
12 >
I=IBCD
(Flashing)
The LED display should indicate parameter 00, which is the Input
Config
Select
parameter,
and
the
current
config type should be flashing in the
upper
line of the LCD display.
(If
not,
press
the
Left
Arrow
button
until this is the case.)
3.
If
you
move
the
Data
Entry Knob now,
you
will select
among
the basic config types.
When
you
stop
moving
the knob, the DP
/4
is reconfigured into the config
showing
on
the
display.
4.
To
edit
the remaining config parameters, press the
Right
Arrow
button
to scroll to
other
parameters
and
move the Data Entry Knob to change their values. You will find a full
discussion of all the parameters for each config type later
in
this
manual
.
•
Note
that
editing some config parameters
may
cause a brief
interruption
in
the
audio
output.
This is
normal
and
is required for the system to reconfigure its signal routing.
ENSONIQ DP/4 Musician's Manual
39
To Next Page
Loading...
Need help?
General
