ENSONIQ DP/4 Musician's Manual

•
Section 2 - Getting Started
Selecting 4 Unit Presets in a 1 Source Config
First, let's select a 1 Source Config:
32
1. Press Select, then press Config.
2 Use the Data Entry Knob to choose Config Preset 54:
1 Src: Stereo In
dr-=-~dr-=-~dr-=-~dr-=-
3. Press Select again. This loads the Config Preset, changing the current Config type to 1
Source, and loading all 4 Units with the Dry (No Effect) algorithm. The DP / 4 automatically
sends you to Unit A.
Now, press any of the other Unit buttons, B, C, or D. Notice that all four Unit LEDs stay lit
no matter which is selected (capitalized). This is because in a 1 Source Config, all four Units
function together, processing the same input signal.
Remember:
In a 1 Source Config, only 4 Unit Presets can be selected. In Select
Mode, you can't view or select 1 or 2 Unit presets without changing to a different
Config. However, it is possible to change 1 Unit presets in Edit mode (for more about
loading a 2 Unit preset while in a 1 Source Config, see Section 8 - Applications).
4. Rotate the Data Entry Knob. Now you can select among the 100 4-Unit presets in the DP /4
Memory. When you have a preset showing that you want to hear, simply press Select to
load the preset.
Only 4 Unit Presets
can be selected.
Each 4 Unit Preset will
load new algorithms
into A, B, C, and D,
along with routing info
between units.
There are 50 ROM
and 50 RAM
4 Unit
Presets
to choose from.
00 dst~spk~ddl~rev
~ c~p~ddl~fla~rev
~ exc~c~p+ddl#fla
03
04
05
06 ... 99
ENSONIQ DP/4 Musician's Manual

ENSONIQ DP/4 Specifications

General

Brand	ENSONIQ
Model	DP/4
Category	Recording Equipment
Language	English