ENSONIQ DP/4 Musician's Manual

Section 7 - Storage
Copying Presets
The DP /4 can also copy presets to other RAM locations. To do this:
1. If the Select LED is not on, press the Select button.
2. Press the Write-Copy button. The top line of the display shows one of four possible screens:
I!::I~:::::: ••••• ~. · =~ •• ~:::::: •••• ·•· •••••••• ···· =· t::::::o :::::::::::::1 =U:::::: ••••••• · .~=. · ••• · ~.:::::: · ~. · ~::ta]II!::~:::::: •••••• ~ · =.~ •• ~:::::: ••••••••••••••• =t::::::o :::::::::::::4::::::U .... :::::: ......... ~= •••• ~ •.• ::::::~ .• ~:::m]
This shows that you are copying a 1 Unit preset. This shows that you are copying a 4 Unit preset.
This shows that you are copying a 2 Unit preset. This shows that you are copying a Config preset.
The screen that appears and the type of preset that will be copied is determined by the
current contig and the unit that is active when you press Write-Copy. The rules which
govern this are the same as in Select mode . You can copy what you have most recently
selected
in the current contig.
3. Press the Cancel- Undo if you wish to exit from the copy procedure and return to Select
mode. This may be necessary if the preset type is not what you expected to copy. Make sure
that the Contig LED is not on unless you wish to copy a contig preset.
4. Use the Data Entry Knob to choose a new location (preset numbers 00 through 49) to copy
your preset. The LED numeric display shows the destination number for your preset .
5. Press the Write-Copy button a second time to copy your preset. The display will
momentarily show the same u*WRITE OK*/I message that appears when saving a preset from
Edit mode (see above).
6. You have just successfully copied your preset.
ENSONIQ DP/4 Musician's Manual 159

ENSONIQ DP/4 Specifications

General

Brand	ENSONIQ
Model	DP/4
Category	Recording Equipment
Language	English