ENSONIQ DP/4 Musician's Manual

Section 6 - System-MIDI Mode
Reinitializing the DP/4
If your DP / 4 is behaving in peculiar ways (the display is showing alphanumeric characters that
shouldn't be there or unexplainable Unexpected Event messages) and a soft reset (or turning the
DP / 4 power off and then on again) won't cure the problem, try reinitializing the DP / 4.
To reinitialize the DP/4:
1. While holding down the System-MIDI button,
2 Press the Unit B button.
3.
Then use the Right Arrow button to scroll to this page:
Hit <WRITE) To
re i nit i ali ze ~ ~ ~
Press the Cancel- Undo button to quit without reinitializing the system.
Press the Write-Copy button at this point to reinitialize the DP / 4. Remember that by doing this
you will replace
all of the RAM Preset data in the DP / 4, and all System-MIDI parameters will be
reset to their default Range!
If reinitializing the DP / 4 does not correct the problems you are encountering, then contact an
Authorized ENSONIQ Repair Station.
Note: In the unlikely event of a system malfunction, you can save your entire set-up
(all Presdt Banks and System parameters) with a System Exclusive dump by pressing
the Write button. This will help you restore all of the user-defined parameters. For
more information about System Exclusive dumps, see Section 6 - System-MIDI Mode .
ENSONIQ DP/4 Musician's Manual 153

ENSONIQ DP/4 Specifications

General

Brand	ENSONIQ
Model	DP/4
Category	Recording Equipment
Language	English