,-
Section 4 - Algorithms
06 - PitchShifter Vc 1
Pan
Range: -99 to +99
This
parameter
allows
you
to assign the location of
output
Voice 1 in the stereo field. A value of
-99
would
be far left,
and
+99
would
be far right.
07 - PitchShifter Vc 2 Semi Range: -12 to +12
This
parameter
allows
you
to adjust the pitch of Voice 2
up
to
an
octave above
or
below the
original pitch
in
semi-tones.
08 - PitchShifter Vc 2 Fine Range: -99 to +99
This
parameter
allows
you
to fine
tune
the
pitch
of Voice 2.
09 - PitchShifter Vc 2 Level Range: 00 to
99
This
parameter
allows
you
to adjust the volume of Voice
2.
A setting of
00
would
eliminate
any
audible
pitch
shift.
10-
PitchShifter Vc 2
Pan
Range: -99 to +99
This
parameter
allows
you
to assign the location of
output
Voice 2 in the stereo field. A value of
-99
would
be far left,
and
+99
would
be far right.
11
- Delay vs Quality
(Pitch Shifter 1 U Only)
Range: Long/Smoother or Short/Coarser
This
parameter
allows
you
to choose between a
long/smooth
setting, or a
short/coarse
setting. A
smooth
setting
would
sound
best
with
slower sustaining chords, whereas a coarse setting
would
enhance a rapidly
played
musical passage.
Depending
on
your
sound
source
and
musical needs,
set this
parameter
accordingly. This parameter actually controls the effect
transport
delay;
smooth
yields a
long
transport
delay, coarse yields a short transport delay.
PitchShifter LFO Rate Range: 00 to
99
This
parameter
controls the rate of pitch
modulation
which creates a chorusing effect. To achieve
chorusing, this
rate
must
be
very low.
PitchShifter LFO Width
Range: 00 to
99
This
parameter
controls the excursion of pitch modulation. Since the rate is usually very low,
then
the
width
is
usually
very large.
Mod1 Source
Mod1
Destination
Mod1 Param Range Min
Mod1
Param Range Max
Mod2
Source
Mod2 Destination
Mod2 Param Range Min
Mod2 Param Range Max
See the descriptions
under
the Algorithm
Modulators
earlier
in
this section.
ENSONIQ DP/4 Musician's Manual
109
To Next Page
Loading...
Need help?
General
