Section 4 - Algorithms
09 - Comp Noise Gate Off Below Range: -96 to +00 dB
This parameter sets the lower threshold level
at
which the noise gate
shuts
off the audio.
10 - Comp Noise Gate On Above Range: -96 to +00 dB
This
parameter
sets the
upper
threshold level
at
which the noise gate passes audio. This higher
second threshold
prevents
false
"tum
ons."
11
- Gate Release Time Range: 1
ms
to 10.05
This
parameter
determines
how
long
it takes for the gate to
be
fully released after the
input
signal
drops
below the threshold level.
Lower
settings yield a quick gate.
12-
Bass Fc
Range: 0
to
1000 Hz
This parameter sets the cutoff frequency of
the
lower frequency
band
shelving filter.
13 - Bass EQ Gain Range: -48 to +24 dB
This
parameter
sets the
amount
of
boost
or
cut
applied to the
low
shelving filter.
14 - Treble Fc Range:
01
KHz
to 16KHz
This
parameter
sets the cutoff frequency of
the
upper
frequency
band
high
shelving filter.
15 - Treble EQ Gain Range: -48 to +24 dB
This
parameter
sets
the
amount
of
boost
or
cut
applied to the
high
shelving filter.
16 - EQ Input Level Trim Range: -24
to
+00 dB
This
parameter
allows
you
to
adjust
the
input
volume of the EQs, to eliminate the possibility of
clipping boosted signals.
17 -
Mod1
Source
18 -
Mod1
Destination
19 -
Mod1
Param Range Min
20 -
Mod1
Param Range Max
21
- Mod2 Source ·
22 - Mod2 Destination
23 - Mod2 Param Range Min
24 - Mod2 Param Range Max
See the descriptions
under
the Algorithm Modulators earlier
in
this section.
ENSONIQ DP/4 Musician's Manual
115
To Next Page
Loading...
