ENSONIQ DP/4 Musician's Manual

I ~
Section 4 - Algorithms
07 - Exp Release
Range: 1 ms to 10.0s
This parameter determines how long it takes for the expansion to be fully deactivated after the
input signal rises above the threshold level. This is generally longer than the attack time.
08 - Exp Noise Gate Off Below Range: -96 to +00 dB
This parameter sets the lower threshold level at which the noise gate shuts off the audio.
09 - Comp Noise Gate On Above
Range: -96 to +00 dB
This parameter sets the upper threshold level at which the noise gate passes audio. This second
parameter provides hysteresis.
10- Bass Fc Range: 0 to 1000 Hz
This parameter sets the cutoff frequency of the lower frequency band shelving filter.
11 - Bass EQ Gain Range: -48 to +24 dB
This parameter sets the amount cif boost or cut applied to the low shelving filter.
12 - Treble Fc Range: 01 KHz to 16KHz
This parameter sets the cutoff frequency of the upper frequency band high shelving filter.
13 - Treble EQ Gain
Range: -48 to +24 dB
This parameter sets the amount of boost or cut applied to the high shelving filter.
14 - EQ Input Level Trim Range: -24 to +00 dB
This parameter allows you to adjust the level of the signal entering the EQ, to eliminate the
possibility of clipping
boosted signals.
15 - Mod1 Source
16 - Mod1 Destination
17 - Mod1 Param Range Min
18 - Mod1 Param Range Max
19 - Mod2
Source
20
- Mod2 Destination
21 - Mod2 Param Range Min
22 - Mod2 Param Range Max
See the descriptions under the Algorithm Modulators at the beginning of this section.
ENSONIQ DP/4 Musician's Manual
121

ENSONIQ DP/4 Specifications

General

Brand	ENSONIQ
Model	DP/4
Category	Recording Equipment
Language	English