EasyManua.ls Logo

ENSONIQ DP/4 - Page 98

ENSONIQ DP/4
212 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
82
Section 4 - Algorithms
08 - DDL+LFO Delay Regen
Range:
-99
to
+99
This
parameter
controls the
amount
of regen (regeneration) applied to the delay time taps. The
sign of
the
value
determines
the polarity of
the
regen.
09 - DDL+LFO Delay Cross Regen Range:
-99
to
+99
This
parameter
allows
you
to feedback
the
delayed
signals to their opposite sides;
the
left voice
crosses to the
right
voice,
and
the right voice crosses to the left voice. A setting of +99
or
-99
will
cause infinite delay.
Be
careful,
if
the
delay
regen
is
set
too high, it
may
cause this parameter to
"blow
up."
10 - DDL+LFO Regen Damping Range:
00
to
99
Adjusts
the
cut
off
of
a
low
pass
filter
on
the feedback signal, which controls the
amount
of
damping
to the feedback Signals. The
higher
the
number,
the more the signals are
damped.
11
- DDL+LFO Right Delay Input Range: Off or
On
This
parameter
disables the
input
into
the
right
side delay line. The right delay line will still get
input
from
the Cross Regen. This allows a
ping-pong
delay effect.
12 - DDL+LFO Right Output Level Range:
00
to
99
This
parameter
controls the
right
output
signal level.
13-
Bass Fc
Range: a to 1000
Hz
This
parameter
sets the cutoff frequency of
the
lower
frequency
band
shelving filter.
14 - Bass EQ Gain Range: -48 to +24
dB
This
parameter
sets the
amount
of boost or
cut
applied
to the low shelving filter.
15 - Treble Fc Range:
01
KHz
to
16KHz
This
parameter
sets the cutoff frequency of the
high
shelving filter.
16 - Treble EQ Gain Range: -48 to +24
dB
This
parameter
sets
the
amount
of boost
or
cut
applied
to the
high
shelving filter.
17 - EQ Input Level Trim Range: -24 to +00
dB
This
parameter
allows
you
to
adjust
the
input
volume
of the EQs to eliminate the possibility of
clipping boosted signals.
18 - Mod1 Source
19 - Mod1Destination Parameter
20 - Mod1 Param Range Min
21
- Mod1 Param Range Max
22 - Mod2
Source
23 - Mod2 Destination Parameter
24 - Mod2 Param Range Min
25 - Mod2 Param Range Max
See the descriptions
under
the Algorithm Modulators, found
in
the beginning of this section.
ENSONIQ
DP/4
Musician's Manual

Table of Contents

Other manuals for ENSONIQ DP/4

Related product manuals