Entec EVRC2A-N6-NT - Page 77

RECLOSER CONTROL EVRC2A-N6,NT http://www.entecene.co.kr
67
ENHANCED TECHNOLOGY
Calling Number
In order to set “Calling Number”, go to “PRIMARY, ALTERNATE or EDITBANK SETTING /
RELAY SETUP / COMMUNICATION / DIALUP MODEM-1 or DIALUP MODEM-2 /
CALLING NUMBER” menu.
COMMUNICATION / DIALUP MODEM / CALLING NUMBER
①
②
③
④
Insert [Modem(Master station) phone number] for calling.
Total 16 numbers can be inputted. If numbers under 16 are inputted, the
rest should be inputted with “X”.
Insert “Calling Number” which a user wants at ①.
1) Use [▲], [▼] button to change each number(0~9, X) and use [◀],
[▶] button to move a cursor.
2) Press [ENT] button after changing and then ② is shown.
“Calling Number” is changed if [ENT] button is pushed. Changing
setting is completed and then ③ is shown.
If the [ESC] button is pushed at ②, ④ is shown, but changed setting is
not applied yet.
NOTE :
The changed setting is effective after it is saved at
“*.SAVE SETTING”
menu.
[NEW CALLING NUMBER]
0000000000000XXX
!!! SAVE ABORT !!!
[NEW CALLING NUMBER]
0000000000000XXX
!!! SAVE OK !!!
[NEW CALLING NUMBER]
0000000000000000
PRESS ENTER TO SAVE
[CALLING NUMBER]
0
000000000000000