Enterasys D2G124-12

Completing the Installation
2-36 Installation
c. FordetailsonhowtoconfiguretheD2usingthecommandlineinterface,refertothe
EnterasysD‐SeriesCLIReference.TheCLIcommandsenableyoutosetanewpasswordand
performmoreinvolvedmanagementconfigurationsontheD2.
Ifyourequireassistance,contactEnterasysNetworksusingoneof
themethodsdescribedin
“GettingHelp”onpage xvii.
Note: It is strongly recommended that you change the admin password from its default state of
blank (no password), once the D2 switch becomes operational in your network. For more
information, refer to the Enterasys D-Series CLI Reference
.