Enterasys D2G124-12 - Resetting the D2-HIPWR-POE

Resetting the D2-HIPWR-POE
Enterasys D-Series Hardware Installation Guide 3-3
Resetting the D2-HIPWR-POE
TheD2‐HIPWR‐POEwillshutdownintheeventofanoverloadorshortcircuit.
ToresettheD2‐HIPWR‐POE:
• DisconnectACpowertooneofthepowersupplies.Wait30seconds(toallowtheDCoutput
voltagetodecayenoughtoresettheD2‐HIPWR‐POE)beforere‐
applyingACpower.
•RemoveandreplaceoneoftheD2‐HIPWR‐POE’spowerinputcables,nominimumtime
required.