Epson ES-C380W - Scanning Using WSD

❏ On (Full-Auto):
Start scanning when an original is set while the continuation conrmation message is displayed.
❏ On (Semi-Auto):
Start scanning when the Start Scanning button is pressed while the continuation conrmation
message is displayed.
Detect Double Feed:
Display a warning when multiple originals are fed at the same time.
❏ Length:
Detect a double feed by the length. When the length of the second original scanned is dierent
from the
rst,
this is
identied
as a double feed. You can specify the
dierence
in length for
detection.
File Name:
❏ Filename Prex:
Enter a prex for the name of the images in alphanumeric characters and symbols.
❏ Add Date:
Add the date to the le name.
❏ Add Time:
Add the time to the le name.
Clear All Settings
Resets the scan settings to their defaults.
Scanning Using WSD
Note:
is feature is only available for computers running Windows Vista or later.
If a destination computer is not displayed, follow the steps below to add a WSD scan device.
“Adding a WSD Scan Device” on page 122
1. Place the originals.
2. Select WSD on the home screen of the scanner’s control panel.
3. Select a destination.
4. Tap
x .
5. Follow the on-screen instructions when the WSD Scan Device screen is displayed on your computer.
Adding a WSD Scan Device
Depending on your environment, you may need to add a WSD scan device on your computer.
e following procedure is an example for Windows 10. e procedure may dier depending on your
environment.
Scanning > Scanning from the Control Panel (the Scan to Features) > Scanning Using WSD
122