Epson ES-C380W - Placing Large Size Originals

Note:
❏ If the document extends beyond the input tray extension, support the document with one hand to prevent it from
falling from the ADF. Also, while scanning an original, support both ends of the original with your hands to prevent
it from tilting.
❏ When scanning thin paper originals such as yers or receipts, or when scanning originals that tend to curl aer
scanning, we recommend extending the paper output support in both places.
Aer
loading the original, press the buttons (two places) to raise the paper output support.
❏ When scanning originals such as business cards that tend to curl aer scanning, we recommend scanning in the
straight path position and only loading one original at a time.
❏ if you cancel scanning in the middle of scanning a batch of originals, the second original will be fed a little bit into
the ADF and then scanning stops. Open the scanner cover to remove it, and then load the page again together with
the
rst
page and the rest of the originals.
❏ Depending on the type of paper and the environment in which the scanner is being used, the original may fall from
the front of the scanner aer scanning. In this situation, load fewer originals into the scanner than the specied
number of originals that can be loaded.
Placing Large Size Originals
Note:
❏ Use a Carrier Sheet when scanning wrinkled, fragile, or valuable originals.
“Placing Important Originals or Photos” on page 82
❏ Make sure there is enough space in front of the scanner for the ejected originals.
1. Make sure that the scanner position icon is (straight path position).
Placing Originals > Placing Originals in the Scanner > Placing Large Size Originals
60