Epson ES-C380W - Specifications for Originals that Can be Scanned; General Specifications for Originals Being Scanned; Scannable Standard Size Originals

Specications for Originals that can be Scanned
is section explains the specications and conditions of originals that can be loaded in the ADF.
General Specications for Originals Being Scanned
Type of Original Thickness Size
Fine paper
Plain paper
Recycled paper
Post cards
Business cards
Envelopes
Plastic cards complying with ISO7810
ID-1 type (with or without emboss)
Laminated cards
Thermal paper
When scanning in the vertical path
position: 40 to 127 g/m
When scanning in the straight path
position: 40 to 413 g/m
When scanning A6 size or smaller
originals: 40 to 209 g/m
Max: 215.9×5,588 mm (8.5×220.0 in.)
Min: 50.8×50.8 mm (2.0×2.0 in.)
The loadable size varies depending on
the type of the originals, the scanning
resolution, and the scanning method.
Note:
❏ All originals must be at at the leading edge.
❏ Make sure that curls on the leading edge of the originals are kept within the following range.
A
must be 5 mm or less.
B
must be 3 mm or less.
C
must be greater than or equal to
B
if
B
is less than 1 mm. When
B
is greater than 1 mm, it should be at least 10
times the size of
B
.
❏ Even when the original meets the specications for originals that can be placed in the ADF, it may not feed from the ADF
depending on the paper properties or quality. Additionally, some originals may decrease the scan quality.
Scannable Standard Size Originals
ese are the specications for standard size originals that you can scan.
Placing Originals > Specications for Originals that can be Scanned > Scannable Standard Size Originals
43