Epson ES-C380W - Scan to WSD Work Flow; Scanning from the Control Panel (the Scan to Features); Saving to a Computer

Scan to WSD Work Flow
Necessary Operations Operation
Location
Explanations
1. Connect the scanner and the
computer to the network
(This is unnecessary if you connected
to the network during setup)
Scanner and
computer
Connect the scanner to the network using the installer.
Access the following website, and then enter the product
name on the screen displayed. Go to Setup, and then start
setting up.
https://epson.sn
When the connection method selection screen is displayed,
select wireless LAN (Wi-Fi) and follow the on-screen
instructions to connect to the network.
Note:
❏ When you use the installer, the soware is installed at
the same time.
❏ You can also set this manually. (for administrators)
“Connecting the Scanner to the Network” on page 236
2. Scan from the control panel Scanner’s control
panel
Perform scanning from the control panel.
“Scanning Using WSD” on page 122
Note:
If the destination computer is not displayed, follow the
steps below to add a WSD scanning device.
“Adding a WSD Scan Device” on page 122
Scanning from the Control Panel (the Scan to
Features)
Saving to a Computer
Saves the scanned image to a computer connected to the scanner.
You need to make settings in advance. See the following link for details on the work ow for making settings.
“Scan to Computer Feature Work Flow” on page 100
1. Place the original.
Example: For standard paper
“Placing Standard Size Originals” on page 55
2. Select Computer on the home screen on the control panel.
3. Select the computer to which you want to save the scanned images.
4. Select the scanning side from 1-Sided or 2-Sided.
Scanning > Scanning from the Control Panel (the Scan to Features) > Saving to a Computer
104