Epson ES-C380W - Scan to Computer Feature Work Flow; Scan to USB Drive Feature Work Flow; Scan to Cloud Feature Work Flow

Scan to Computer Feature Work Flow
is section explains how to save scanned images to a connected computer.
Necessary Operations Operation
Location
Explanations
1. Install the software on your
computer and connect the scanner to
your computer
(This is unnecessary if you installed the
software connected during setup)
Scanner and
computer
Perform the following operations using the installer.
❏ Install the necessary software on your computer
❏ Connect the scanner to the computer
You can access the installer from the following website.
Access the URL, and then enter the product name on the
screen displayed. Go to Setup, and then start setting up.
https://epson.sn
2. Scan from the control panel Scanner’s control
panel
Perform scanning from the control panel.
“Saving to a Computer” on page 104
Scan to USB Drive Feature Work Flow
is
section explains how to save scanned images to a USB drive connected to the scanner.
Necessary Operations Operation
Location
Explanations
1. Connect the USB drive to the
scanner
Scanner Insert a USB drive into the scanner's external interface USB
port.
“Inserting a USB Drive” on page 26
2. Scan from the control panel Scanner’s control
panel
Perform scanning from the control panel.
“Saving to a USB Drive” on page 105
Scan to Cloud Feature Work Flow
Use Epson's cloud service, Epson Connect to send scanned images to registered destinations.
❏ You can easily send scanned images by email by registering an email address as the destination.
❏ You can send scanned images to third-party online storage services (Evernote, Google Drive, Dropbox, and so
on) by registering them as the destination. For details on how to register an account, see the website for each
service. Available services are subject to change without notice.
Note:
For more details about Epson Connect services, visit the following portal website.
https://www.epsonconnect.com/
http://www.epsonconnect.eu (Europe only)
Scanning > Preparing to Scan from the Control Panel (the Scan to Features) > Scan to Cloud Feature Work Flow
100