Epson ES-C380W - Setting up the Ieee802.11 K;V or Ieee802.11 R Features

7. Enter the IP address for the primary DNS server.
Conrm the value reected on the previous screen.
Note:
When you select Auto for the IP address assignment settings, you can select the DNS server settings from Manual or
Auto. If you cannot obtain the DNS server address automatically, select Manual and enter the DNS server address.
en,
enter the secondary DNS server address directly. If you select Auto, go to step 9.
8. Enter the IP address for the secondary DNS server.
Conrm the value reected on the previous screen.
9. Tap Start Setup.
Setting the Proxy Server
Set up the proxy server if both of the following are true.
❏ e proxy server is built for Internet connection.
❏ When using a function in which a scanner directly connects to the Internet, such as Epson Connect service or
another company's cloud services.
1. Select Settings on the home screen.
When making settings
aer
IP address setting, the Advanced screen is displayed. Go to step 3.
2. Select Network Settings > Advanced.
3.
Select Proxy Server.
4. Select Use for Proxy Server Settings.
5. Enter the address for the proxy server by IPv4 or FQDN format.
Conrm the value reected on the previous screen.
6. Enter the port number for the proxy server.
Conrm
the value
reected
on the previous screen.
7. Tap Start Setup.
Setting up the IEEE802.11k/v or IEEE802.11r Features
1. Access Web Cong, and then select the Network tab > Basic.
2. Set IEEE802.11k/v or IEEE802.11r to enabled or disabled.
3. Click Next.
e setting conrmation screen is displayed.
4.
Click OK.
Administrator Information > Connecting the Scanner to the Network > Setting up the IEEE802.11k/v or IEEE …
239