Epson ES-C380W - Resetting the Number of Scans after Cleaning Inside the Scanner; Replacing the Roller Assembly Kit

Related Information
& “Cleaning Kit Codes” on page 41
& “Replacing the Roller Assembly Kit” on page 182
Resetting the Number of Scans After Cleaning Inside the Scanner
Aer performing regular cleaning, reset the scan number on the control panel or by using the Epson Scan 2 Utility.
is section explains how to reset using the control panel.
1.
Tap Scanner Maintenance on the home screen.
2. Tap Regular Cleaning.
3. Tap Reset the Number of Scans.
4. Tap Ye s .
Note:
To reset from the Epson Scan 2 Utility, start the Epson Scan 2 Utility, click the Maintenance tab, and then click Reset in
Regular Cleaning. If you cannot click Reset, select Regular Cleaning Alert.
Replacing the Roller Assembly Kit
e roller assembly kit (the pickup roller and the separation roller) needs to be replaced when the number of scans
exceeds the life cycle of the rollers. When a replacement message is displayed on the control panel or your
computer screen, follow the steps below to replace it.
A: Separation Roller, B: Pickup roller
Note:
Replace the roller assembly kit while the scanner is turned on.
Maintenance > Replacing the Roller Assembly Kit
182