1. Wipe o any stains on the roller. Open the vertical path cover.
c
Important:
When opening the vertical path cover, hold the area indicated to avoid touching the antistatic brush. If the
brush becomes bent it cannot eliminate static electricity, and this may cause the output originals to stick to each
other.
2. Wipe the rollers (4 locations) and the plastic rollers (4 locations). Wipe with a so, lint-free cloth dampened
with a small amount of dedicated cleaner or water.
c
Important:
Be careful not to touch the antistatic brush when wiping the rollers. If the brush becomes bent it cannot
eliminate static electricity, and this may cause the output originals to stick to each other.
Maintenance
>
Cleaning Inside the Scanner
175
To Next Page
Loading...
