Epson ES-C380W - Page 252

Item Settings and Explanation
Enable WSD Select this to enable adding devices using WSD and scan
from the WSD port.
Scanning Timeout (sec) Enter the communication timeout value for WSD scanning
between 3 to 3,600 seconds.
Device Name Displays the WSD device name.
Location Displays the WSD location name.
LLTD Settings
Item Settings and Explanation
Enable LLTD Select this to enable LLTD. The scanner is displayed in the
Windows network map.
Device Name Displays the LLTD device name.
LLMNR Settings
Item Settings and Explanation
Enable LLMNR Select this to enable LLMNR. When this is enabled, you can
use name resolution without NetBIOS even if you cannot use
DNS.
SNMPv1/v2c Settings
Item Settings and Explanation
Enable SNMPv1/v2c Select to enable SNMPv1/v2c.
Access Authority Set the access authority when SNMPv1/v2c is enabled. Se-
lect Read Only or Read/Write.
Community Name (Read Only) Enter within 32 characters in ASCII (0x20-0x7E). If you do not
specify this, leave it blank.
Community Name (Read/Write) Enter within 32 characters in ASCII (0x20-0x7E). If you do not
specify this, leave it blank.
Allow access from Epson tools Set whether to allow writing from Epson tools such as Epson
Device Admin.
SNMPv3 Settings
Item Settings and Explanation
Enable SNMPv3 SNMPv3 is enabled when the box is checked.
User Name Enter between 1 and 32 characters using 1 byte characters.
Authentication Settings
Administrator Information > Advanced Security Settings > Controlling Using Protocols
252