Epson ES-C380W - Page 96

5. Load the originals with the side to be scanned facing up and in descending order of paper size with the widest
at the back and the narrowest at the front of the input tray.
c
Important:
Check the following points when setting dierent sizes of originals.
❏ Slide the originals with their leading edges aligned, until they meet resistance in the ADF.
❏ Set the originals at the center of the input tray. Refer to the
u mark on the scanner as your guide.
❏ Set the originals straight.
If not, originals may be fed askew or jammed.
6. Align the edge guides with the widest original.
Note:
❏ If you cancel scanning in the middle of scanning a batch of originals, the second original will be fed a little bit into the
ADF and then scanning stops. Open the scanner cover to remove it, and then load the page again together with the rst
page and the rest of the originals.
❏ Depending on the type of paper and the environment in which the scanner is being used, the original may fall from the
front of the scanner aer scanning. In this situation, load fewer originals into the scanner than the specied number of
originals that can be loaded.
Placing Originals > Placing Originals in the Scanner > Loading Batches of Originals with Dierent Paper Types an …
96