REV.-A
DISASSEMBLY, ASSEMBLY, AND ADJUSTMENT
3.
Remove the CBB(c) (M3 x 10) screw and the CBS(c) (M3 x 8) screw securing the SAMA board to the
base plate and the lower case.
4.
Loosen the four bent tabs on the lower case, securing it to the SAMA board. Then remove the SAMA board.
to cause damage to components on the SAMA board.
NOTES FOR REASSEMBLY
The figure below shows the appropriate way to handle the cable connecting the SAMA and SANPS(E) boards.
Figure 4-9. Cable
LQ-510
4-9
To Next Page
Loading...
