DISASSEMBLY, ASSEMBLY, AND ADJUSTMENT
REV.-A
NOTES FOR REASSEMBLY
1.
When reinstalling, position the carriage guide shaft and the head adjust lever as shown in Figure 4-30.
riage Guide Shaft
Figure 4-30. Carriage Guide Shaft and Head Adjust Lever
2.
The lever for the left side of the guide shaft is gray; the lever for the right side is black. Slide each lever
onto the appropriate side of the shaft.
3.
When connecting the head cable, be sure to pass it correctly through the FFC guide on the frame.
Following reassembly of the carriage unit adjust the platen gap Platen gap adjustment is detailed in
4-22
LQ-510
To Next Page
Loading...
