SC-F2000 Revision C
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 108
Confidential
Installing the DAMPER KIT, attach the sponges, film (1) and
film (2) of the INK MIST COVER ASSY. (p114)
Make sure to tighten the screw that secures the TUBE ASSY
using a torque driver with the following torque.
0.39 ± 0.05 N/m
Before installing the joint, make sure the Joint Rubbers are
attached to it.
Before attaching the Joint Rubber, let it get wet with cleaning
liquid.
Always use new Joint Rubbers.
Insert only Joint Rubber per line between upper Joint and
lower Joint.
Confirm there are no foreign objects attached on the Joint
Rubbers.
To Next Page
Loading...
