SC-F2000 Revision C
ADJUSTMENT TF Adjustments 272
Confidential
[Blue]: Button or menu name on the program screen / [Black]: Button or menu name on the operation panel of the printer
Figure 4-85. Turning the adjustment screw
5. Pull out the TABLE ASSY from the main body.
6. Tighten the fixing screw loosened in Step 2.
7. Adjust the other three positions in the same manner.
8. After the adjustment, go back to the check procedure and check the parallelism.
Make sure to perform the adjustment by turning the adjustment
screw in the plus direction (clockwise). If you want to adjust it in
the minus direction, once turn the adjustment screw
counterclockwise (minus direction) a lot, then perform the
adjustment in the plus direction (clockwise).
Plus direction
(clockwise)
Minus direction
(counterclockwise)
To Next Page
Loading...
