Epson TM-P20II

132
10.5.2 Change Administrator Password
In this area, the user can change the authentication information for an administrator.
The settings that are configured by the user in this area are used when an administrator logs on.
10.5.2.1 Top Page
10.5.2.1.1 Image
Figure 10-61 Change Administrator Password
10.5.2.1.2 Setting Items
The following table shows the items on the page.
Table 10-154 Setting Items

Items
Description
Condition
"Current password"
Text box for entering the current
password
-
"New Password"
Text box for entering the current user's
name.
Usable string: ASCII code (0x20-0x7E)
from 0 to 20 characters.
-
"Enter between 1 and 20 characters."
Message for entering characters.
-
"Confirm New Password"
Text box for entering a new password.
Usable string: ASCII code (0x20-0x7E)
Max of 20 characters.
However, if the password is against the
password policy, the setting will fail.
-
"Note: It is recommended to communicate
via HTTPS for entering an administrator
password. "
Message for entering characters.
-
Setting Items
Button