133
10.5.2.1.3 Button
The following table shows the buttons on the page.
Table 10-155 Button
When the “OK” button is pressed, Web Config displays a pop-up window with the following message if it recognizes an error in
the entered value.
Table 10-156 Error Pop-up
10.5.2.2 Result Page
The result message is shown in the main frame after the “OK” button is pressed.
10.5.2.2.1 Image
Figure 10-62 Image
10.5.2.2.2 Setting Result
Table 10-157 Result
Button at the bottom of the page
"Restore Default Settings"
If pressed, Web Config restores the
setting values to the factory defaults.
Displayed only on models that
support the initial value for the
When the format of the entered user name or password is not correct,
this message is shown.
"Password and confirm password do not match."
When new password and the confirmation password do not match,
this message is shown.
This message is shown when the settings are completed.
After that, Web Config reloads the page and displays the product
status page.
If an administrator was logged on previously, Web Config maintains
administrator logon mode. If a user other than an administrator was
logged on, Web Config exits administrator logon mode.
"Failed to make the settings."
"The password you entered is incorrect."
This message is shown if the current password entered by the user is
incorrect.
None of the setting items on this page are applied to the printer.
"The password does not meet the password
policy requirements. Check the requirements."
This message is shown if setup fails due to a violation of the Password
Policy.
This message is shown if setup fails for a reason other than those
described above.
Setting Result
To Next Page
Loading...
Need help?
General