Epson TM-P20II

15
7. User Authentication
7.1 Authentication Method
Web Config uses the administrator user name and password to perform user authentication. This same password is also used for
locking the device’s control panel and for EpsonNet Config password authentication. If a password is not configured,
administrator rights are granted for all access to Web Config. The various states of administrator authentication are shown below.
Table 7-1 Administrator authentication state
7.2 Pages Always can be Accessed
The following pages are accessible all the time regardless of the administrator's logon status.
Table 7-2 Pages Always can be Accessed

Administrator user name is
configured
Administrator user name is not
configured
Administrator password is
configured
Authentication is requested.
Authentication is requested. However,
the administrator is not required to
enter a user name.
Administrator password is not
configured
Transit to "Administrator Password
Setting" page.
Displays the "Set Administrator
Password" page.
Tab menu
Sub menu
Status
Product Status (contains Software Licenses)
Network Status
sage Status
Hardware Status