50
10.2.1.2.1 Image
The following figure shows the layout of the results page.
Figure 10-5 Image
10.2.1.2.2 Setting Result
Table 10-16 Setting Result
Restarting communication may
take a few minutes.
If you want to change the
settings, reconnect to the Web
This message is shown when the settings are completed successfully.
This message is shown if setup fails.
"Cannot access the product
until processing is complete."
This message is shown when the setting is unavailable because the product is
processing.
Setting Result
To Next Page
Loading...
Need help?
General