Ericsson AVP 4000 - Page 155

Front Panel Control
1/1553-FGC 101 1790 Uen Y
4-15
Change State
Sets the Setmode state of the Transport Stream. The options
available depends on the value set for MGP Mode under
Advanced/System/MGP Support.
Transport Stream Bit Rate The Bit Rate of the Transport Stream.
Reserved Bit Rate The Bit Rate of the ???.
Bit Rate Tracking Mode
Off, Maximise video. Enables or disables Bit Rate tracking for the
current Transport Stream.
Auto Enable
If set to true, it automatically re-enables the Transport Streams
when all the specified error conditions are cleared.
Auto Disable
Never, Audio Lost, Video Lost, Any Upstream CRITICAL Alarm, Any
CRITICAL alarm. Disables the output when the set condition is met.
The Transport Stream can be set to be re-enabled at the Auto
Enable option.
Syntax DVB, ATSC
Programme Specific Information
Transport Stream ID
A new ID can be assigned to the Transport Stream.
PAT
-PMT On, Off
PAT
-PMT Parameters
PMT Repetition Period
100 ms, 400 ms, 500 ms. Specifies how often (in ms) the PMT shall
be transmitted.
Dolby Digital Descriptor
DVB, ATSC, DVB & ATSC
CAT
On, Off
TSTD
On, Off
Service Information
Original Network ID
NIT
On, Off
NIT Parameters
Network Name
Set Network Name
Network ID
Set network ID.
Generate LCN
Off, IEC 62216, NorDig v1, DTG Default
Send Extended NIT
- SIRG
On, Off. If PSI/SI Level is set to On (PAT/PMT/SDT/CAT/NIT) make
sure the Send extended NIT (SIRG) is On so that the Carrier ID is
sent.
Insert NIT into PAT
True, False
SDT
On, Off
Add Existing Transport Stream
Creates a copy of an existing Transport Stream at the current
output. Displayed only if no Transport Stream is defined for the ASI
output.