Default after Timeout: Maintains previously received AFD code for period
specified in Sustain Timeout, then drop to default, i.e. code 1000.
Off after Timeout: Maintains previously received AFD code for period specified
in Sustain Timeout, then switch AFD off.
AFD Sustain Timeout
0 to 5, 10, 20, 50, 100, 120. Control how long previous AFD code is
maintained. Zero means drop to default immediately on loss.
AFD Action on Reserved Codes Pass Thru, Code as 0000.
Specify what code is passed to the output when reserved AFD codes are
received at the input.
Pass Thru: Passes code through unchanged.
Code as 0000: Changes code to 0000.
Closed Captions
Closed Captions Source Off, SPMTE 334.
Timecode
TC Mode
Off, External, Zero on Loss, External, Freewheel on Loss, Internal. Controls
what mode the Time code (TC) is working in, either Off, external source or
internally generated. Also sets what happens on loss of external source (zero
or freewheel).
TC External Source
Auto, ANC VITC1, ANC VITC2, ANC LTC, VBI VITC. Controls the external
source of Time Code. Auto will select the first source present in order of the
drop down list.
TC Dropframes Off, On, Auto.
Broadcaster ID
Reception Timeout Enables entry/editing of reception timeout.
Insertion Timeout Enables entry/editing of insertion timeout.
Broadcaster ID Mode Off, Auto, Default Only, Source Only.
Default Servicename Enables entry/editing of service name.
Broadcaster ID Source Displays broadcaster ID source.
Broadcaster ID Displays broadcaster ID.
Generic ANC
Generic ANC Extraction
On, off. Controls whether Generic ANC is extracted from the SDI stream or not
as per SMPTE 2038-2008.
Max ANC Bit Rate 100 to 2000 kbps. The maximum data rate of the Generic ANC data output.
Teletext DVB syntax only.
Teletext Source Off, VBI lines.
Teletext Packetisation
Normal (ETS 300-472) - Data on Teletext Component, Legacy (ETS 301-775) -
Data on VBI Component. Controls how the Teletext data is packetized in to a
component data stream.
Min # Teletext Packets
0 to 3. Defines the minimum number of Teletext packets generated per field,
even if there is no Teletext data.
PTS on Teletext
Off, on. Controls whether a PTS value is included in the output Teletext
To Next Page
Loading...
