Received Reflex Msg
Device Rx Counter
Device Tx Counter
Socket Rx Counter
Socket Tx Counter
PCR Excg Rx Counter
PCR Excg Tx Counter
Set Rate Src IP Addr
PCR Exchange Src IP Addr
SCR diff to be applied to
ClocksFPGA
Second Video
PIP
Audio Module
Advanced
AC-3 PMT / Descriptor Syntax
Audio <n>
Input
Format
Uncompressed (LPCM), MPEG Layer II, Dolby Digital, Dolby Digital Plus,
Dolby E, AAC. Sets the input format used by the audio encoder.
Source
Off, Mute, Test Tone, Embedded 1 to 8. Sets the source used by the audio
encoder. No input is fed to the encoder if Off is selected. Mute mutes the
incoming audio and encodes silence. Test Tone encodes an 1 kHz test tone,
Embedded 1 to 8 sets the source to an SDI embedded audio stream.
Output On Audio Loss
No PID, Silence. Specifies the action to take when input is Lost. No PID is for
dropping the audio PID from the stream, Silence is for encode silence.
NOTE: When No PID is selected, the reference to the PID is not removed from
the Program Map Table, so a Transport Stream analyzer will indicate a ghost
PID in the output Transport Stream.
Downmix Parameters
Downmix Type Lo/Ro downmix, Lt/Rt downmix. Specifies the downmix type..
Downmix metadata override Off, on. Specifies the downmix override.
Downmix metadata reversion mode
If available, maintain last received metatdata values, otherwise use fixed
settings, Use fixed settings. Specifies the downmix metadata reversion mode.
Center mix level
0.707 (-3.0 dB), 0.595 (-4.5 dB), 0.500 (-6.0 dB). Specifies the center mix
level.
Surround mix level 0.707 (-3.0 dB), 0.500 (-6.0 dB), 0 (-inf dB). Specifies the surround mix level.
Use Preferred Stereo Downmix if
Available
Off, on. Enables the preferred stereo downmix, if available.
To Next Page
Loading...
