Operation & Software Manual
40
Direct Drives & Systems
Chapter B: System setup & tuning ETEL Doc. - Operation & Software Manual # DSC2P 903 / Ver. F / 3/6/05
7.3 Install ETEL Tools software
7.3.1 System requirements
The PC minimal configuration to install the ETEL Tools software (ETT) is:
• Windows 9x / 2000 / NT / XP
• Pentium processor 166 MHz, or faster
• RAM 64 Mo, or greater
• Hard disk free space 250 Mo, or greater
• Screen definition 800x600 pixels, or more
• CD-ROM drive
•Mouse
7.3.2 Installing ETT
You should have received ETT on a CD-ROM. The version 4.11 or above must be used to take all these
controllers and functionalities into account. To install it, proceed as follows:
• Open the directory ETEL Tools 4.xx (the number of the version will change with new releases)
• Run the Setup.exe application
• Follow the installation steps:
a) Read and accept ETEL's License agreement.
b) Choose the destination directory for ETT (by default it is: C:\Program Files\ETEL).
c) The program folder will be ETEL Tools 4.xx by default.
d) The installation will take a few minutes, depending on your PC performances.
e) A shortcut called ETEL Tools 4.xx (will change with new releases) has been created on your desktop. If
you look in your Windows Start menu under Programs, you will find an ETEL Tools 4.xx directory,
containing shortcuts to 2 files: ETEL Tools 4.xx, and Documentation.
• Restart your PC after the installation is completed.
To Next Page
Loading...
Need help?
General
