ETEL Doc. - Operation & Software Manual # DSC2P 903 / Ver. F / 3/6/05 Chapter B: System setup & tuning
Operation & Software Manual
Direct Drives & Systems 71
8.7.2 Unit conversion
• Choose between Position, Speed or Acceleration in the
first scroll menu.
• Select also the Axis number in the second scroll menu.
• If required, you may change the ISO unit (Position, Speed or Acceleration).
• With a click on the buttons below, you may upload / download Position, Speed or Acceleration, for each
line separately, and convert their values:
Upload directly from the controller (increments) the Position, Speed or Acceleration value to the
corresponding line (Inc and ISO). This is an increment > ISO value conversion.
Download directly to the controller (increments) the Position, Speed or Acceleration value (inc.
and ISO) from the corresponding line. This is an ISO > increment value conversion.
Example:
The controller is in ’Power On’ mode. The user wants to Download into the controller the following line:
Position / Axis 0 / 65536000 [Inc] / 160 / mm (click on the Download button)
This is like sending the following command from the terminal: POS.0 = 65536000 (Enter)
Note: The position value sent is always an absolute position!
To Next Page
Loading...
Need help?
General
