EVS Multicam Version 10.01 – Operating Manual
EVS Broadcast Equipment SA – July 2009
Issue
10.01.F
85
RESET
The RESET key: resets the default values of the search criteria (no from/to
date) and set the default TC to the TC of loaded on the PGM.
RETURN
The RETURN key (A) is used to exit the Search function without performing
any search.
SEARCH LOC / SEARCH NET
Once the search criteria are defined, press SRCH LOC (C) to search the
local clips database, or SRCH NET (D) to search the entire network
database.
The matching clips are the ones that contain all keywords used as search
criteria, and that have at least
the requested ranking.
If matching clips are found, the remote will automatically be in Browse mode
(the BROWSE key is red), allowing the operator to quickly view the Short IN
of each clip corresponding to the search criteria by rotating the jog dial. To
be able to jog inside a clip, disable the Browse mode by pressing on the
BROWSE key and move the jog dial. To return to the Browse mode inside
the search results, press the BROWSE key again.
Search results are reset when going by to LIVE mode, or when a new search
is performed.
If no matching clips are found, a message notifies the operator.
ADDING THE SEARCH RESULTS TO THE CURRENT PLAYLIST
It is possible to directly add all search results (clips only) to the current
playlist.
Press ENTER on the selected clip to insert only that one.
Press SHIFT+ENTER to insert all clips to the end of the current playlist.
To Next Page
Loading...
Need help?
General
