Extron electronics DTP CrossPoint 84 - Software Operational Considerations and Installation

DTP CrossPoint 84 Series Matrix Switchers • Programming Guide 63
Command Function
SIS Command
(Host to Unit)
Response
(Unit to Host)
Additional description
Scaler Output Commands
Brightness
Set a specific
brightness value
EX1(*X2(BRIT} BritX1(*X2(]
Specify the brightness adjustment.
Increment brightness
value
EX1(+BRIT} BritX1(*X2(]
Increase the brightness setting by one.
Decrement brightness
value
EX1(–BRIT} BritX1(*X2(]
Decrease the brightness setting by one.
View the brightness
value
EX1(BRIT} X2(]
Show the brightness setting.
Contrast
Set a specific contrast
value
EX1(*X2(CONT} ContX1(*X2(]
Specify the contrast adjustment.
Increment contrast
value
EX1(+CONT} ContX1(*X2(]
Increase the contrast setting by one.
Decrement contrast
value
EX1(–CONT} ContX1(*X2(]
Decrease the contrast setting by one.
View the contrast value
EX1(CONT} X2(]
Show the contrast setting.
Detail
Set a specific detail
value
EX1(*X2(HDET} HdetX1(*X2(]
Specify the detail adjustment.
Increment detail value
EX1(+HDET} HdetX1(*X2(]
Increase the detail setting by one.
Decrement detail value
EX1(–HDET} HdetX1(*X2(]
Decrease the detail setting by one.
View the detail value
EX1(HDET} X2(]
Show the detail setting.
Horizontal Shift
Specify a value
EX1(*X3)HCTR} HctrX1(*X3)]
Set the horizontal location of first active
pixel in output
X1(.
Increment value
EX1(+HCTR} HctrX1(*X3)]
Increment the value by one pixel (shift the
image to the right).
Decrement value
EX1(–HCTR} HctrX1(*X3)]
Decrement the value by one pixel (shift the
image to the left).
View
EX1(HCTR} X3)]
Show the horizontal location of first active
pixel in output
X1(.
Vertical Shift
Specify a value
EX1(*X3)VCTR} VctrX1(*X3)]
Set the vertical location of first active line in
output
X1(.
Increment value
EX1(+VCTR} VctrX1(*X3)]
Increment the value by one line (shift up).
Decrement value
EX1(–VCTR} VctrX1(*X3)]
Decrease the value by one line (shift down).
View
EX1(VCTR} X3)]
Show the vertical location of first active line
in output
X1(.
Horizontal Size (Image)
Specify a value
EX1(*X3)HSIZ} HsizX1(*X3)] Set the horizontal of output X1(.
Increment value
EX1(+HSIZ} HsizX1(*X3)]
Increment the value by one pixel (make one
pixel wider).
Decrement value
EX1(–HSIZ} HsizX1(*X3)]
Decrement the value by one pixel (make
one pixel narrower).
View
EX1(HSIZ} X3)] Show the horizontal size of output X1(.
KEY: X1( = TP (scaled) and insertion output number 03 or 04
X2( = Picture adjustments 000 through 127 (064 = default)
X3) = Position and size ±10240 (Horizontal is specified from left, vertical from top)