FARGO electronics DTC500 Series - Page 11

RESTRICTED USE ONLY FARGO Electronics, Inc.
DTC500 Series Card Printer/Encoders Troubleshooting Guide (Rev. 3.0)
11
Troubleshooting the LCD Messages (continued)
Message Cause Solution
EE Checksum
Error
Indicates that the permanent
circuit board memory is bad.
See Resolving the EE Checksum
Error on page 181.
EE Memory Error Indicates that the permanent
circuit board memory is bad.
See Resolving the EE Memory Error
on page 181.
Ejecting Used
Card
Indicates that the system
Firmware has detected a
card already in the Printer.
This card has been ejected; however,
it may contain encoded data and
should be disposed of in a proper
manner.
Failed To
Initialize
Indicates that an unexpected
hardware error has occ
urred.
See Board Errors on page 181.
Flipper Alignment Indicates that the Printer is
unable to align the Flipper
table.
See Resolving the Flipper Alignment
Error Message on page 64.
FPGA Indicates that an unexpected
hardware error has occurred.
See Resolving the FPGA Error on
page 183.
FPGA Load Fail Indicates that an unexpected
hardware error has occurred.
See Resolving the FPGA Error on
page 183.
FPGA Timeout Indicates that an unexpected
hardware error has occurred.
See Resolving the FPGA Error on
page 183.
Head Lift Indicates that the Printer was
unable to raise or lower the
Printhead.
See Resolving the Headlift Error
Message on page 53.
Continued on the next page