FARGO electronics DTC500 Series - Page 5

RESTRICTED USE ONLY FARGO Electronics, Inc.
DTC500 Series Card Printer/Encoders Troubleshooting Guide (Rev. 3.0)
5
Using the Image Color tab ______________________________________________ 123
Using the K Panel Resin tab_____________________________________________ 127
Selecting the Full Card with the K Panel Resin tab_________________________ 128
Selecting the Defined Area(s) with the K Panel Resin tab ___________________ 129
Selecting the Undefined Area(s) with the K Panel Resin tab _________________ 130
Defining the Area to activate the Card Grid ______________________________ 131
Measuring the Total Card area_________________________________________ 132
Defining the positioning of the area on the Card ___________________________ 134
Selecting the Print YMC under the K and Print K Only options_______________ 136
Using the Magnetic Encoding tab ________________________________________ 138
Using the Encoding Mode option ______________________________________ 139
Encoding the Mode / Coercivity / Magnetic Track Selection _________________ 141
Using the Magnetic Track Selection option_______________________________ 143
Using the Magnetic Track options ______________________________________ 144
Using the Bit Density radio buttons_____________________________________ 145
Using the Character Size radio buttons __________________________________ 145
Using the ASCII Offset ______________________________________________ 146
Using the LRC Generation radio buttons_________________________________ 147
Using the Character Parity radio buttons _________________________________ 147
Using the Verification option__________________________________________ 148
Reviewing the Shift Data Left _________________________________________ 149
Reviewing the ISO Track Locations ____________________________________ 150
Reviewing the Sample String__________________________________________ 150
Sending the Track Information ________________________________________ 151
Reviewing the ASCII Code and Character Table __________________________ 152
Using the Overlay / Print Area tab________________________________________ 153
Using the Overlay / Print Area dropdown menu ___________________________ 154
Using the Overlay / Print Area_________________________________________ 155
Using SmartShield Area dropdown menu ________________________________ 161
Using the Card tab ____________________________________________________ 162
Selecting the Card Size ______________________________________________ 163
Using the Card Hopper Selection (DTC515 / DTC525 only) option ___________ 165
Reviewing the Orientation ____________________________________________ 168
Specifying the Copies _______________________________________________ 168
Using the Test Print button ___________________________________________ 169
Clicking on the About button__________________________________________ 170
Using the Image Position button _______________________________________ 171
Using the Lamination tab (only with Card Lamination Module) ________________ 174
Selecting the Lamination Position ______________________________________ 175
Selecting the Lamination Side _________________________________________ 176
Selecting the Lamination Type ________________________________________ 177
Selecting the Lamination Type ________________________________________ 178
Adjusting the Transfer Dwell Time and Transfer Temperature________________ 179
Selecting the Sensors button and Defaults button __________________________ 179
Calibrating the Card Lamination Module’s Lamination Sensor _______________ 180
Board Level Diagnostics ________________________________________________ 181