RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 191
Cleaning the Platen Rollers
Clean the Printer's Platen Rollers approximately every 1,500 prints or as needed depending
on the cleanliness of the card stock and the environment in which the Printer is located.
Step Procedure
1 Clean if the Rollers appear dirty or if the cards start showing speckles or debris
on the printed surface. See Steps 2 to 6 (below).
2 Leave the power ON and open the Printer's Top Covers.
3 Remove the Print Ribbon and overlaminate.
4 Locate the Platen Rollers.
5 a. Use a Cleaning Pad from the Printer Cleaning Kit to wipe the Rollers clean.
b. Press the On/Cancel button and the Pause/Resume button to move the
Rollers back and forth while cleaning.
6 After the Rollers are clean and completely dry, replace the printing supplies and
close the Printer.
To Next Page
Loading...
