RESTRICTED USE ONLY Fargo Electronics, Inc.
Pro-LX Laminating Card Printer/Encoder User Guide (Rev. 5.0) 47
Resolving the Card Feeding Errors (continued)
Step Procedure
2 Ensure the Card Thickness Slide is set correctly.
a. Loosen the Slide Lock by rotating it counter clockwise and then push the
Card Thickness Slide forward or backward to the appropriate setting.
b. With any of the Card Thickness settings, move the slide slightly toward a
higher setting until the cards begin feeding (if the Printer seems unable to
feed cards at the selected setting).
c. Move the slide slightly toward a lower setting if the Printer seems to double-
feed cards. (Note: The card thickness slide is adjustable to accommodate
card thickness variations that often occur even within standard card sizes.)
3 Check for static build up between cards.
Occasionally, a static charge will build up between the surfaces of two or
more cards causing them to stick together.
By separating the cards manually before placing them in the input Hopper,
this static charge can be reduced or eliminated.
To Next Page
Loading...
