Festo CMMS-AS Series User Manual

CMMS-AS/CMMS-ST/CMM D -AS
Festo – GDCP-CMMS/D-FW-EN – 1404NH – Engli sh 9
Instruc tions on this description
This doc umentation is intended to help you work safely with the motor controller CMMS-AS/CMMS-ST/
CMMD-AS and describes the functions, commissioning procedure and error messages.
Target group
This documentation is intended exclusively for technicians trained in c ontrol and automation techno-
logy, who have experience in installation, commissioning, programming and diagnostics of positioning
systems.
Versions
This documentation refers to the following versions:
Motor controller
Version
CMMS-AS-... Motor controller CMMS-AS-C4-3A-G2: From Rev 03
Firmware: From version 1.4.0.2.6
FCT plug-in CMMS-AS: From version 2.0.0.x
CMMS-ST-... Motor controller CMMS -ST-C8-7-G2: From Rev 05
Firmware: From version 1.4.0.1.6
FCT plug-in CMMS-ST: From version 2.0.0.x
CMMD-A S -... Motor controller CMMD-A S-C8-3A: From Rev 03
Firmware: From version 1.4.0.3.6
FCT plug-in CMMD-AS : From version 2.0.0.x
Note
Before using a newer firmware version, check whether a newer version of the FCT plug-
in or documentation is available
 Support portal: http://www.festo.co m/ sp.
Service
Please consult your regional Festo contact if you have any technical problems.
Product identification
For additional information about the rating plate and manufac turing date  “Mounting and installa-
tion” desc ription, GDCP-CMMS-AS-G2-HW-…/GDCP-CMMD-AS-HW-…/GDCP-CMMS-ST-G2-HW-…

Festo CMMS-AS Series Specifications

General

Brand	Festo
Model	CMMS-AS Series
Category	Controller
Language	English