Fike FCP-300 - Page 90

90 FCP-300/FCP-300ECS Manual — P/N LS10145-002FK-E:A 3/12/2021
Programming Overview Programming Menu Quick Reference
System
Options
Communication
Options
Auto Time Test
Set the Hour
*02:00AM
Section
Set the Minutes
Select AM/PM
Enter Interval
24 hrs, 12 hrs, *6
hrs, 4 hrs
Phone Lines
For each phone line (1 & 2) select:
Dialing Prefix Up to 9 digits *none
See “Phone Lines” on
page 136.
# of Answer Rings Range: 00-15 *06
Number of rings before
panel answers a call
from a computer See
“Phone Lines” on
page 136.
Select Dialing Option
TT
*TT
Touch Tone
TT/PL
TouchTone alternating
with pulse see See
“Phone Lines” on
page 136.
PULSE Pulse dialing
Rotary Pulse Format
U = 60/40
*U
See “Phone Lines” on
page 136.
E = 66/34
Dial Tone Disabled Y or N *N
Monitor Line Y or N *N
Answering Machine
Bypass
Y or N *N
Phone Line Unused Y or N *N
Edit Ethernet
IP Address
See “Edit Ethernet” on
page 138.
Subn Mask
SubNet
Default Gateway
DHCP Enable
System
Options
cont.
Communication
Options
AlarmNet Timers
Ethernet Supervise
75 sec, 90 Sec, 3
min, 5 min, 1 hr,
24 hrs, 30 days,
None
*5 Minutes
See “AlarmNet Timers”
on page 138.
Old Alarm Time
10 min, 15 min,
30 Minutes, 1 hr,
2 hrs, 4 hrs, 8
hrs, 12 hrs,
24hrs, none
*30 Minutes
Phone Line Gains
Dialing
High
*High
See “Phone Line Gains”
on page 138.
Low
Normal
Reporting
Low
*LowNormal
High
Daytime/Nighttime
Sensitivity
Enable/Disable
Yes
*No
See “Daytime/Nighttime
Sensitivity” on page 139.
No
Day Start Enter time *6:00AM
Night Start Enter time *6:00PM
Days of the Week Select days *-MTWTF-
Holiday Days Holidays 1 to 18 Enter dates
*01/01,07/04,
12/24, 12/25
Section 9.6.3
Time Options
Water Flow Delay 0 - 90 Seconds *1 sec
Section 9.6.4
Alarm Verify 60 to 250 seconds *60 sec
Low AC Report Time 0 - 30 hours *3 hrs
AC Freq:
50 Hz
*60Hz60 Hz
Internal
Clock Display Format
AM/PM
*AM/PM
MIL
Auto-resound
4 hours
*24 hours
24 hours
Miscellaneous
Options
SYNC Strobes when Silenced
Y
*N
Section 9.6.5
N
Auto Display Events
Y
*N
N
Menu Options/Defaults Comments
Table 8.4 Programming Quick Reference Chart (Continued)