MMS
®
Inspection DPM High
11
General Features
Factory Calibration Each individual gage is factory calibrated at several reference points with the greatest care to en-
sure the highest possible degree of trueness.
Measuring sensors The gage contains senors for measuring air temperature, surface temperature and relative humidi-
ty; specifications see page 5
Data memory The memory content is preserved even when there is no voltage supply; subsequent viewing of the
measured single readings and evaluations
Memory capacity of 250,000 readings in up to 2500 batches
Evaluation Statistics
Display of mean value, standard deviation, min/ max values, number of stored readings, range, co-
efficient of variation, date and time for each variable relative humidity (RH), air temperature (Ta),
surface temperature (Ts), dew point (Td) and Ts-Td
Graphic Presentation
Run-Chart, showing the progress of stored readings of each climatic variable; the scaling of Y chart
axis are specified by the set limits
Indication for monitoring alarm
Limit violation: optical by red illuminated LED
Languages Many different display languages, beside German and English several other European and Asian
languages
Date & Time
Setting of date and time
Setting of date and time format
Presetting for batches Each batch is created with a preset measurement temperature unit; you can change this measure-
ment unit at any time
Display
Graphic display with automatic flipping measuring presentation view (disabeling) to read
measurement results in many different gage positions
Setting of brightness and contrast (definable for Office, Sunlight and Night)
Data transfer
USB: Data transfer of individual measurements of all climatic variables to a PC
Data export into MSExcel via Add-In program PC-Datex; You can download the PC-Datex program
free of charge from Fischer-Download page, https://docs.helmut-fischer.com/st9
Data export into the evaluation, recording and archiving software Fischer DataCenter (from ver-
sion 2.6); You can download the Fischer DataCenter program free of charge from Fischer-Down-
load page, https://docs.helmut-fischer.com/st9
USB: Data transfer of individual measurements of all climatic variables to a CAQ system
Bluetooth: Data transfer of individual measurements of all climatic variables to a PC
Data export into MSExcel via PC-Datex software; You can download the PC-Datex program free of
charge from Fischer-Download page, https://docs.helmut-fischer.com/st9
Data export to software Fischer DataCenter is not possible.
Bluetooth: Data transfer of individual measurements of all climatic variables to a CAQ system
USB port 2.0 Type C
For connection to PC for data transfer, max. cable length: 3 m (118 inches)
For service purpose
Bluetooth Bluetooth module integrated in gage, Bluetooth 4.2
Frequency range: 2402 … 2480 MHz, max. output power: 6.13 dBm
Temperature connector Type K, to connect an external type K temperature sensor, e.g., magnetic surface temperature sen-
sor (606-036)
To Next Page
Loading...
