FISCHER MMS - Page 73

Gage settings
69
MMS
®
Inspection DPM High
10.2.3 Flip display
You can enable and disable the automatic flip display function according to the
gage position.
Navigation
: Selects – parameter/value
: Confirms – selection/setting
Enables/Disables – function
:Exits – page/menu
To enable/disable the display flip function
► Main menu ( ) > Gage Settings > OK > Display Settings > OK > Flip
Display > OK
Automatic Flip Display function is enabled:
Automatic Flip Display function is disabled:
The setting is finished.
What you can do next
 Go to the Measurement view: 2x > , measure, see page 28.
 Make further display settings: > OK.
 Make further gage settings: 1x .
 Go to the main menu: 2x .
OK